CFexpress Type B Card Failed in Cinema Camera? Pro Recovery
Our founder and lead technician, Joseph Montanti, handles cases personally.
A CFexpress Type B card measures 29.6 × 38.5 × 3.8 mm and uses PCIe with the NVMe storage protocol. If one fails in your camera, a compatible reader may still be able to copy the footage; an undetected or unstable card needs a different recovery approach. Keep the recording card unchanged until its files have been copied or imaged, including when the camera asks to format it.
On this page
CFexpress Type B size, readers and Type A differences
Type A, B and C are different physical sizes with different numbers of PCIe lanes. The version number is separate: CFexpress 2.0 uses PCIe Gen3, while 4.0 uses Gen4. The CompactFlash Association specifications give these dimensions and lane counts:
| Specification | Type A | Type B | Type C |
|---|---|---|---|
| Card size | 20 × 28 × 2.8 mm | 29.6 × 38.5 × 3.8 mm | 54 × 74 × 4.8 mm |
| PCIe lanes | 1 | 2 | 4 |
| Storage protocol | NVMe | NVMe | NVMe |
The association's card guide says Type C currently has no camera or card products. Type B shares its dimensions and connector with XQD, but reader and camera support must include CFexpress specifically. CFast 2.0 is another format altogether, using SATA. A CFast reader is the wrong reader for CFexpress Type B.
A printed maximum transfer speed describes performance under specified conditions. Sustained recording speed, the reader, the computer's port and the destination drive all affect the speed you see. RED lists these offload limitations for its Type B reader.
When the card reports an error during a take
Interrupted recording can leave the last clip unfinished while earlier clips remain readable. A camera also needs enough sustained write speed for the selected recording mode. Nikon's Z8 error guide distinguishes a card-access error from a recording interruption caused by insufficient write speed.
- If the camera is already off, leave it off. If the camera still responds, end recording with its record button and let it finish accessing the card. Do not pull the card while the access light is active.
- Before touching the card, let it cool. On a powered Nikon Z8, wait for the X card-temperature warning to clear to avoid a burn. Follow the camera's removal procedure. For the Nikon Z8, Nikon says to wait for the access lamp to go out, turn the camera off and then eject the card.
- Mark the card as failed and put it aside in its protective case. Continue recording on a different, compatible card only if the camera is otherwise working normally.
Protect the footage still on the card. Decline formatting, repair and firmware-update prompts until the original has been preserved. Keep wet or damaged media out of cameras and readers, and never freeze a card to try to make it read.
Separate a reader problem from a failed card
If the camera's slot looks undamaged and the door latches normally, test a known-good spare card in that same body. A bent pin, faulty door or repeated errors with the spare point to camera service. Leave the suspect card out of other cameras. Use a reader explicitly supporting CFexpress Type B. The card's physical fit in an XQD slot is insufficient. Check the reader with a compatible spare card that contains nothing you need; if that card also fails, check the reader, its cable and the computer connection before blaming the recording card.
For an undamaged card with no overheating or repeated errors, one check in a known-working compatible reader can show whether the camera's access error follows the card. If the card mounts and its clips copy normally, transfer the whole recording folder to another drive before trying playback or camera repair. Stop the transfer if the card repeatedly drops out, returns read errors or becomes unusually hot while idle.
If files are missing but the card is detected consistently at its proper capacity, a full image preserves the readable sectors for recovery work. It also includes areas outside the current file listing, which an ordinary folder copy leaves behind. Save that image to another disk with enough space for the card's full capacity, keep the original image unchanged and work from a duplicate. The GNU ddrescue manual explains image-based recovery and why file-system repair belongs on the copy.
A zero-capacity card or one that never appears as a readable storage device cannot supply a normal software scan. Lexar lists those conditions, physical damage and abnormal reported capacity among its recovery software exclusions. Repeatedly changing scanning programs does not restore that missing hardware access.
Lexar, Angelbird and recovery options
For a Lexar card, use the exact product series and the camera's approved-media list when checking compatibility. GOLD, SILVER and DIAMOND models have different specifications. Lexar's DIAMOND 4.0 product sheet lists a minimum sustained write speed of 3,200 MB/s and peak write speed of 3,400 MB/s for the 1 TB Professional DIAMOND CFexpress 4.0 Type B.
Lexar offers a free recovery tool for Mac and Windows. Its exclusions also include CFexpress cards with TRIM enabled. A deleted or formatted card can therefore behave differently from an older card where all the previous data remains available to a scan. Preserve the card before software work, and check the software's support for the specific video format you need.
Angelbird has a manufacturer recovery service. Its warranty page limits included recovery to eligible products, so check your card's coverage before sending it elsewhere. Request recovery if you need the footage.
Firmware advice is model-specific too. Angelbird's release notes identify updates for particular AV PRO and RED PRO cards. Apply maintenance updates after the files are secured. Updating the only card containing a missing production is not a substitute for preserving it.
Recovery when CFexpress storage is inaccessible
Inside the card, a controller manages the NAND flash and translates the computer's sector addresses into physical storage locations. The same kind of address mapping is described in Micron's flash-storage power-loss paper. A file-system scan needs that storage to be accessible first. Damage to the controller, its firmware or the NAND can interrupt the path before any clip can be read.
Keeping the original electronics intact preserves the components and information needed to investigate it. Opening the case, swapping parts or trying a firmware reset before examination can complicate that work. For a card that remains undetected in a working reader, the next step is a recovery assessment.
| Failure type | Recovery price |
|---|---|
| File system corruption | $1,000 to $1,500 |
| Mid-write video corruption with partial clips | $1,000 to $1,500 |
| Card not detected, controller responds | Quoted after assessment |
| Severe physical damage | $1,500 to $2,000+ |
At MDrepairs, the $100 diagnostic is credited toward a successful recovery, and you approve the recovery estimate before work begins. The pricing page covers the terms. If your production has a deadline, the standard recovery estimate is 4–6 weeks and may vary by case; rush options advance the start of assessment.
Check the camera model and the media it recorded to
Cameras in the same product family can use different cards. The V-RAPTOR 8K VV records R3D to CFexpress Type B. RED lists its 660 GB card in that camera's media guide. Check approval for the exact body and recording mode. For the XL [X], RED's Type B media guidance identifies RED PRO cards and links its alternative approved products.
| Camera | Recording media | Relevant difference |
|---|---|---|
| Nikon Z8 | CFexpress Type B/XQD and SD | Check recording-mode support for the selected slot |
| Nikon Z9 | Two CFexpress Type B/XQD slots | It has no SD slot |
| Canon EOS R5 C | CFexpress Type B and SD | Cinema RAW Light uses CRM files |
| Canon EOS R3 | CFexpress Type B and SD | Its RAW movie format is CRM |
| Panasonic GH6 | CFexpress Type B and SD | Internal ProRes and external ProRes RAW are different recording paths |
| Blackmagic Pocket Cinema Camera 6K Pro | CFast 2.0 and SD | Use the reader for the card holding the BRAW clips. |
| Blackmagic URSA Mini Pro 12K | CFast 2.0, SD or supported external storage | Its card slots are not CFexpress |
| Blackmagic URSA Cine 12K LF | Blackmagic Media Module | The CFexpress module holds Type B cards; other modules contain different storage |
| Original RED KOMODO 6K | CFast 2.0 | Different from the Type B media used by V-RAPTOR and KOMODO-X |
| Z CAM E2 Mark II series | CFexpress Type B | Earlier E2 models used CFast; identify the exact model |
For the GH6, Panasonic specifies ProRes RAW through an external HDMI recorder. If that was your setup, the RAW originals are on the recorder's storage. Two slots in a camera also do not automatically create two copies of every recording format. Check any second card or recorder that was configured to record during the take.
BRAW, N-RAW and ProRes RAW files that will not play
Recovering a file's name and size is only part of recovering a clip. The encoded frames and the information that organizes them must also be readable. A file interrupted while recording may need reconstruction, and a fragmented clip may occupy several separated areas of the card. Test recovered copies in software supporting the original codec before deciding the shoot is recovered.
Blackmagic RAW: Keep the .braw files together with any matching .sidecar files. The sidecars hold metadata adjustments, rather than another copy of the footage. Blackmagic RAW Player supports playback of BRAW clips, and the SDK documentation explains how embedded and sidecar metadata work.
Nikon N-RAW: Look for .NEV originals and the matching .MP4 proxies. Nikon documents a 1080p proxy recorded with N-RAW. A surviving proxy may give you a usable view of the take even when the RAW original is damaged. Nikon's RAW playback guidance also explains that NX Studio displays the MP4 proxies, so test the original in software that supports N-RAW.
ProRes RAW: Nikon records it in a MOV file. On a Mac, Apple's ProRes RAW guidance calls for Pro Video Formats to enable viewing in QuickTime Player and Quick Look.
Canon RAW: R5 C Cinema RAW Light and R3 RAW movies use CRM files. Preserve the entire copied recording folder and use software supporting that camera's RAW files. Renaming a CRM or NEV extension to MOV does not convert its contents. For a partial clip, keep the recovered file alongside any repaired version.
Get help with data recovery
Bring your device to our Lincroft lab during opening hours, or mail it in.
How to mail your deviceThe $100 diagnostic is non-refundable once diagnostics start, and donor drives or replacement parts you approve are non-refundable once ordered, even if recovery fails.
Published by MDrepairs
MDrepairs is a data recovery and electronics repair lab in Lincroft, New Jersey. Our founder and lead technician Joseph Montanti films real cases for our YouTube channel, showing tools, repair steps and recovery outcomes.
Keep reading
- USB “Device Descriptor Request Failed”: What It Means for a Flash Drive
- USB Says “Please Insert a Disk” or “No Media”: Can You Recover the Files?
- SD Card Write Protected? Fixes Beyond the Switch
