Board repairs saved pictures from a pool-damaged iPhone
- Device
- iPhone
- What happened
- Would not turn on after falling into a pool
- What was wrong
- Missing components and a trace, plus solder bridging unintended connections after prior work
- Result
- Recovered. The pictures were saved after missing connections and components were restored and stray solder removed.
An iPhone stopped working after falling into a pool, and the owner wanted the pictures recovered. When Joe removed the motherboard, he saw signs of earlier work. Several components were missing. He first took replacements from a donor board and installed them on the customer's board.
Joe then found a missing trace and ran a jumper wire to restore that electrical connection. As he inspected further, he discovered low-melt solder smeared across the board. It was connecting points that should not have been connected, so he cleaned it away before continuing.
There was also low-melt solder beneath a chip that needed to be replaced. Joe took a replacement chip from a donor board and reballed it, adding new solder connections underneath. He installed it on the customer's motherboard. The owner's pictures were saved.
If yours is similar
Missing parts and stray solder complicated this pool-damaged iPhone's recovery, making its earlier board work part of the diagnostic. Pause further repair attempts until the remaining components and connections have been inspected.
iPhone Data RecoveryThe people we help
